| Directions of Mystery Swinging Clock
1. Technical Parameters:
1.1 Timing-running tolerance: average tolerance per day is +4 to –4 minutes for 8 day running.
1.2 Running duration: it can run for 8 days continuously after being wound once.
2. Installation procedures (please refer to Schematic Drawing below)
2.1 Stably place the wooden base with the statue
2.2 Fix the bracket into the nostril of the statue. Firstly, fix the bracket screw (6 in Schematic figure) into the above mentioned position noting that the funnel shaped swinging hole (8) must be vertically upwards. Then twist the bracket fixing screw nut (7) until it is tightened.
2.3 Wind clockwise the winding knob (4) to its full range.
2.4 Twist clockwise the hand adjusting knob (5) to standard time.
2.5 Gently place the two center tips (1) in the two bracket swinging holes, and then swing the lower half of the clock to either right or left direction with one finger. It will enter into normal working condition after a while.
3. Method for adjustment of time-running error and points for attention.
3.1 Twist the speed adjuster (2) to the left when time is on the fast side; conversely twist it to the right in order that it works within the time running tolerance.
3.2 First of all, you should see if the bracket is fixed at right position and the bracket swinging hole is vertically upwards when clock does not work or stops.
4. Packing list:
4.1 One wooden base with the statue
4.2 One swinger clock (fig. A)
4.3 One bracket (fig. B) | 
